Mars Pro UPS

mars pro online ups, 1000 to 3000 VA

Summary
Topology: Online Double Conversion
Power Range: 1000 to 3000 VA
Input/Output: 1:1
Installation Type: Desktop, Convertible
Isolation: UPS + Isolation transformer (1)
Battery: Internal or External
Features
Wide input voltage and frequency
Rackmount or tower installation
Easy installation (Plug & Play)
Programmable outlets
Optional LCD display
Monitoring via network feature (2)
Mars Pro UPS with Online double conversion topology provides high-reliability protection for sensitive servers and data centers. Inverter with a new design and equipped with intelligent microprocessor control, has provided the possibility of uninterrupted power supply to consumers with full sinusoidal output and stabilized voltage and frequency. The special design of this UPS provides the possibility of rotating the screen, installing it in two ways or in a standard rack (along with the equipment installed in the rack). The RS-232 or USB communication port (if ordered) is used for UPS connection and UPSilon 2000 and Emily 2 monitoring software. The back panel slot is used to install communication modules such as the NetAgent module.

Click for more information...

The device comes with an LED display by default, and if ordered, it can be replaced with an LCD display with the ability to display the status of input, output and batteries. IEC 320 C13 standard outputs are available in 1000 and 2000 power in six numbers and in 3000 power in four numbers, while at 3000 power one IEC 320 C19 standard output number with higher output current is considered. Two IEC outputs per power can be programmed independently, which can be automatically switched on or off by consumers connected to them in certain situations, such as power outages, overload, low battery voltage, and so on. Installation and commissioning of this UPS does not require much technical knowledge and the end user can start the device by reading the instructions in the package.
Zener Mars Pro LED display Zener Mars Pro optional LCD display
Replacement and replacement of Mars Pro UPS batteries is easy; Three or six 12-volt, 7-or 9-amp batteries (depending on the device model) are inserted into this UPS, which can be easily replaced by a user with a four-way screwdriver according to the following steps, if necessary. N. An emergency shut-off terminal (EPO) is installed on the back of the UPS that can be connected to the distribution board to immediately cut off the UPS output if necessary.
(1) It is possible to install the output transformer inside the UPS as a custom equipment.
(2) UPS monitoring under TCP/IP protocol requires SNMP module and under Modbus/Jbus protocol requires RS-485 module.
Step 1 Zener UPS Mars Pro replace the internal battery Step 2 Zener UPS Mars Pro replace the internal battery Step 3 Zener UPS Mars Pro replace the internal battery
Step 4 Zener UPS Mars Pro replace the internal battery Step 5 Zener UPS Mars Pro replace the internal battery Step 6 Zener UPS Mars Pro replace the internal battery
Step 7 Zener UPS Mars Pro replace the internal battery Step 8 Zener UPS Mars Pro replace the internal battery Step 9 Zener UPS Mars Pro replace the internal battery
The Mars Pro UPS is suitable for home, office, data center, computer networks, laboratory medical equipment, transportation and navigation equipment, and safety and security systems. The selling price of this UPS varies depending on the model and power requested. Please contact the sales department of Zener Engineering Company to find out the inventory, receive the price list and purchase the various capabilities of this UPS.
Downloads
Collapse All
Expand All
File Name Volume Update
An Adobe Acrobat file Mars Pro UPS english user manual
1.3 MB
2021-01-20
An Adobe Acrobat file Mars Pro UPS persian brochure
704.2 kB
2021-01-20
Software and Accessories
UPS remote monitoring package
UPS local monitoring software
UPS local monitoring software
UPS remote monitoring
USB port extender
Serial port extender
Modbus/Jbus remote monitoring
Technical Specification
UPS
UPS Model
Input Spec.
Nominal Input Voltage 220 VAC single phase, 50 Hz or 60 Hz
Input Voltage Range min 120 VAC @ 33% load or 160 VAC @ 100% load, max 288 VAC
Input Frequency Range 50 Hz or 60 Hz (tolerance ±5 Hz)
Input Power Factor > 0.99 (full linear load)
Inlet - select a model from top -
Output Spec.
Output Power - select a model from top -
Nominal Output Voltage 230 VAC single phase
Output Voltage Range 200, 208, 220, 230, 240 VAC single phase selectable
Output Frequency Range 50 Hz or 60 Hz (tolerance ±0.1% unless synchronized to line)
Output Power Factor 0.8
Output Voltage Distortion (THDu) < 3% with linear load
Output Wave form Pure sine wave
Efficiency up to 90% in Line mode
Outlet - select a model from top -
Battery Spec.
Type of Battery - select a model from top -
No. × Voltage - select a model from top -
Recharging Time 4 hours to 90%
Protections
Overload 100% < Load < 105% continuous, 105% < Load < 120% for 30 seconds, 120% < Load < 150% for 10 seconds
Protections Over-load, short-circuit, over-voltage, under-voltage, over-temperature, excessive low battery
Alarms Line failure, battery low, over-load, fault conditions
Physical Spec.
Dimensions (W × D × H) - select a model from top -
Weight - select a model from top -
Environmental Conditions
Working Temperature Ambient: min 0 °C, max 40 °C, Recommended for battery life: 20 to 25 °C
Working Humidity max 90% non-condensing
Altitude Level 1000 m @ nominal power (Derating 1% power for every 100 m above 1000 m, max 4000 m)
Noise Level max 50 dBA @ 1 m
Other Features
Communications Standard RS-232 or USB (optional), slot for communications interface, EPO
Standards EN 62040-1, EN 62040-2, EN 61000-3-2, EN 61000-3-3, FCC CLASS A
Ask about this product

Sales and Marketing Department

Ready to register your purchase requests.
Whatsapp
+98 919 468 3960
Zener engineering company (PJS), founded in 1981 is among the most experienced companies in the power and electronics field in Iran. We offer a wide range of products in the field of generating electric power including online, offline and line-interactive UPS both single and three-phase from home and office to medical and industrial applications, sealed lead acid batteries, automatic transfer switch (ATS), monitoring systems, environmental sensors and related accessories. Zener Eng. Co. provides optimal technical support in order to create the best possible customer satisfactory regarding the uninterrupted function of its equipment. This is achieved using over 60 trained personnel. Our colleagues in sales and marketing department and after sales services department are trained to give our valued customers consultation in finding the most suitable products for their need, design and execution of uninterrupted electrical systems while providing special solutions. In addition to manufacturing single and three-phase UPS, sealed lead acid batteries both with Zener brand, Zener engineering company is official and exclusive agent for Riello UPS (from Italy), Ablerex UPS (from Taiwan), Rocket and Newmax batteries (from South Korea), Interberg batteries (from Spain) and Starway batteries (from China).
All rights reserved
COPYRIGHT © 2024
Design by: Hamrad Gostar Asia Technology Development