Sentinel Tower UPS

  • Soon
sentinel tower online ups, 5 to 10 kVA

Zener Sentinel Tower online UPS
Summary
Topology: Online Double Conversion
Power Range: 5 to 10 kVA
Input/Output: 1:1 3:1
Installation Type: Tower
Isolation: UPS + Isolation transformer (1)
Battery: Internal or External (2)
Features
User friendly LCD display
Unity output power factor
Small footprint
Up to 3 UPS in parallel function (3)
Efficiency up to 95% in online mode
Monitoring via network feature (4)
Originality Guarantee
Guarantee Terms
Support & Service
Estimation of required power
Sentinel Tower UPS with Online double conversion topology provides maximum protection for sensitive equipment, especially in the field of information technology. The use of a three-level inverter in this UPS has led to an increase in device efficiency of up to 95% in Online mode, reducing energy losses and increasing system efficiency. Filters installed at the input and output of the UPS eliminate most of the power outages and fluctuations and prevent possible damage to downstream systems. The ER series of this UPS does not have an internal battery and is equipped with a high quality and power switching charger that can charge external batteries with high charge current. The use of a digital fan speed controller increases the fan speed if the load increases and vice versa, leading to a reduction in circuit losses and the noise produced.

Click for more information...

Function selection in ECO, Online and Smart active modes is done using the user-friendly front panel display. With USB ports and RS-232 serial ports, remote emergency terminal (EPO), slots for communication equipment such as the NetMan 204 module and slots for parallel cards, any possible connection to this UPS is well anticipated. On the back panel are two independent IEC 320 C13 programmable outputs that can be programmed to automatically turn on or off connected consumers in certain situations.
(1) It is possible to install output isolating transformers in 5000 and 6000 capacities as custom equipment.
(2) It is possible to provide a battery box compatible with the body of the device, if ordered.
(3) To perform Parallel operation, a parallel card must be provided for each UPS.
(4) UPS monitoring under TCP/IP protocol requires NetMan 204 module and under Modbus/Jbus protocol requires MultiCOM 302 module.
Zener UPS Sentinel Tower front view
Sentinel Tower UPS is suitable for home, office, data center, computer networks, laboratory medical equipment, industrial plants, transportation and navigation equipment, and safety and security systems. The selling price of this UPS varies depending on the model and power requested. Please contact the sales department of Zener Engineering Company to find out the inventory, receive the price list and purchase the various capabilities of this UPS.
Downloads
Collapse All
Expand All
File Name Volume Update
An Adobe Acrobat file Sentinel Tower UPS persian brochure
781.09 kB
2021-01-20
Software and Accessories
PowerShield3 UPS and ATS monitoring software
PowerShield3 Monitoring Soft.
UPS/ATS monitoring software
PowerNetGuard UPS monitoring software
PowerNetGuard Monitoring Soft.
UPS remote monitoring software
NetMan 204 UPS and ATS monitoring module
NetMan 204 Module
UPS/ATS remote monitoring
MultiCOM 302 module
MultiCOM 302 Module
Modbus/Jbus protocol converter
MultiCOM 352 module
MultiCOM 352 Module
Serial port extender
MultiCOM 372 module
MultiCOM 372 Module
Contact, serial port extender
MultiCOM 384 module
MultiCOM 384 Module
Relay contacts
Multi I/O module
Multi I/O Card Module
Relay contacts, protocol converter
MultiCOM 411 module
MultiCOM 411 Module
Profibus remote monitoring
MultiPanel remote monitoring display
MultiPanel Remote Display
Remote monitoring display
Environmental Sensor
Environmental Sensor
Environmental sensor
Technical Specification
UPS
UPS Model
Input Spec.
Nominal Input Voltage - select a model from top -
Input Voltage Range - select a model from top -
Input Frequency Range 50 or 60 Hz (tolerance ±5 Hz)
Input Power Factor > 0.98 (full linear load)
Input Voltage Distortion (THDi) ≤ 5% for single phase input
Inlet Terminal block
Bypass Spec.
Bypass Voltage Range 180 to 264 VAC single phase (selected in ECO mode or smart active mode)
Bypass Frequency Range Frequency selected (±5 Hz configurable)
Output Spec.
Output Power - select a model from top -
Nominal Output Voltage 220, 230, 240 VAC single phase (selectable)
Output Voltage Range 230 VAC ±20%, Static variation ±1.5%, Dynamic variation ≤ 5% in 20 ms
Output Frequency Range 50 or 60 Hz selectable
Output Power Factor 1
Output Voltage Distortion (THDu) < 1% with linear load, < 3% with non-linear load
Output Wave form Sinusoidal
Efficiency up to 95% in Online mode, up to 98% in ECO mode
Outlet Terminal block + 2 × IEC 320 C13
Battery Spec.
Type of Battery - select a model from top -
No. × Voltage - select a model from top -
Recharging Time - select a model from top -
Protections
Overload 100% < Load < 110% continuous, 110% < Load < 130% for 1 hour, 130% < Load < 150% for 10 minutes, more than 150% for 3 second
Protections Over-current, short-circuit, over-voltage, under-voltage, over-temperature, excessive low battery
Alarms Line failure, battery low, over-load, fault conditions
Physical Spec.
Dimensions (W × D × H) 250 × 698 × 500 mm
Weight - select a model from top -
Environmental Conditions
Working Temperature Ambient: min 0 °C, max 40 °C, Recommended for battery life: 20 to 25 °C
Working Humidity max 95% non-condensing
Altitude Level 1000 m @ nominal power (Derating 1% power for every 100 m above 1000 m, max 6000 m)
Noise Level max 48 dBA @ 1 m (in ECO mode)
Other Features
Communications USB, DB9 with RS-232 and contacts, slot for communications interface, REPO and input contacts
Standards European directives: L V 2014/35/EU low voltage Directive EMC 2014/30/EU electromagnetic compatibility Directive Standards: Safety IEC EN 62040-1; EMC IEC EN 62040-2; RoHS compliant Classification in accordance with IEC 62040-3 (Voltage frequency Independent) VFI - SS - 111
Ask about this product

Sales and Marketing Department

Ready to register your purchase requests.
Phone Call
+9821 66 72 3972 (Ext.1)
Whatsapp
+98 919 468 3960
Email us
sales@zenerco.com
Zener engineering company (PJS), founded in 1981 is among the most experienced companies in the power and electronics field in Iran. We offer a wide range of products in the field of generating electric power including online, offline and line-interactive UPS both single and three-phase from home and office to medical and industrial applications, sealed lead acid batteries, automatic transfer switch (ATS), monitoring systems, environmental sensors and related accessories. Zener Eng. Co. provides optimal technical support in order to create the best possible customer satisfactory regarding the uninterrupted function of its equipment. This is achieved using over 60 trained personnel. Our colleagues in sales and marketing department and after sales services department are trained to give our valued customers consultation in finding the most suitable products for their need, design and execution of uninterrupted electrical systems while providing special solutions. In addition to manufacturing single and three-phase UPS, sealed lead acid batteries both with Zener brand, Zener engineering company is official and exclusive agent for Riello UPS (from Italy), Ablerex UPS (from Taiwan), Rocket and Newmax batteries (from South Korea), Interberg batteries (from Spain) and Starway batteries (from China).
All rights reserved
COPYRIGHT © 2025
Design by: Hamrad Gostar Asia Technology Development

This site uses cookies. By click on "I agree" or continuing to browse our website, you agree to our website terms and privacy policy.

Click here for more information.

I agree