Ares Tower UPS

ares tower online ups, 1000 to 3000 VA

Topology: Online Double Conversion
Power Range: 1000 to 3000 VA
Input/Output: 1:1
Installation Type: Desktop, Tower
Isolation: Transformer-less
Battery: Internal or External
Wide input voltage and frequency
Digital fan speed controller
Easy installation (Plug & Play)
Programmable outlets
Optional LCD display
Monitoring via network feature (1)
Ares Tower UPS with Online topology provides a high level of protection for sensitive consumers. The inverter, equipped with intelligent microprocessor control, provides uninterruptible power supply to consumers with full sinusoidal output and stabilized voltage and frequency. It is also possible to place the battery inside the UPS or provide it with a high current charger up to 11.2 amps (custom equipment) to charge external batteries. The slots on the back panel are used to install communication modules such as the NetAgent monitoring module. The RS-232 or USB communication port (if ordered) is intended for UPS connection and UPSilon 2000 and Emily 2 monitoring software. The use of a digital fan speed controller increases the fan speed if the load increases and vice versa, and leads to a reduction in circuit losses and the noise produced.

Click for more information...

Power 1000 has three IEC standard outputs and one output socket, power 2000 has three IEC standard outputs and two output sockets and power 3000 has six IEC standard outputs and two output sockets, while two IEC outputs per power, It can be programmed independently, which can automatically turn on or off the consumers connected to them in special situations, such as disconnection or connection of input power, overload, low battery voltage, etc. UPS comes with LED display by default, but it is possible to provide it with LCD display as custom equipment. An emergency shut-off terminal (EPO) is installed on the back of the UPS that can be connected to the distribution board to immediately cut off the UPS output if necessary.

(1) UPS monitoring under TCP/IP protocol requires SNMP module and under Modbus/Jbus protocol requires RS-485 module.

Zener UPS Ares Tower optional LCD display Zener UPS Ares Tower LED display
Ares Tower UPS is suitable for home, office, data center, computer networks, laboratory medical equipment, safety and security systems. The selling price of this UPS varies depending on the model and power requested. Please contact the sales department of Zener Engineering Company to find out the inventory, receive the price list and purchase the various capabilities of this UPS.
Collapse All
Expand All
File Name Volume Update
An Adobe Acrobat file Ares Tower UPS persian brochure
728.65 kB
Software and Accessories
UPS remote monitoring package
UPS local monitoring software
UPS local monitoring software
UPS remote monitoring
USB port extender
Serial port extender
Modbus/Jbus remote monitoring
Technical Specification
UPS Model
Input Spec.
Nominal Input Voltage 220 VAC single phase
Input Voltage Range min 140 VAC @ 50% load, min 160 VAC @ 100% load, max 300 VAC
Input Frequency Range 50 or 60 Hz (tolerance 45 Hz to 65 Hz)
Input Power Factor ≥ 0.98 (full linear load)
Inlet - select a model from top -
Output Spec.
Output Power - select a model from top -
Nominal Output Voltage 230 VAC single phase
Output Voltage Range 200, 208, 220, 230, 240 VAC selectable
Output Frequency Range 50 or 60 Hz (tolerance ±0.1% unless synchronized to line)
Output Power Factor 0.7
Output Voltage Distortion (THDu) < 3% with linear load
Output Wave form Sinusoidal
Efficiency up to 90% in Line mode
Outlet - select a model from top -
Battery Spec.
Type of Battery - select a model from top -
No. × Voltage - select a model from top -
Recharging Time 4 hours to 90%
Overload 100% < Load < 105% continuous, 105% < Load < 120% for 30 seconds, 120% < Load < 150% for 10 seconds
Protections Over-load, short-circuit, over-voltage, under-voltage, over-temperature, excessive low battery
Alarms Line failure, battery low, over-load, fault conditions
Physical Spec.
Dimensions (W × D × H) - select a model from top -
Weight - select a model from top -
Environmental Conditions
Working Temperature Ambient: min 0 °C, max 40 °C, Recommended for battery life: 20 to 25 °C
Working Humidity max 90% non-condensing
Altitude Level 1000 m @ nominal power (Derating 1% power for every 100 m above 1000 m, max 4000 m)
Noise Level max 50 dBA @ 1 m
Other Features
Communications Standard RS-232 or USB (optional), slot for communications interface, EPO
Standards EN 62040-1, EN 62040-2, EN 61000-2, EN 61000-3, EN 61000-4
Ask about this product

Sales and Marketing Department

Ready to register your purchase requests.
+98 919 468 3960
Zener engineering company (PJS), founded in 1981 is among the most experienced companies in the power and electronics field in Iran. We offer a wide range of products in the field of generating electric power including online, offline and line-interactive UPS both single and three-phase from home and office to medical and industrial applications, sealed lead acid batteries, automatic transfer switch (ATS), monitoring systems, environmental sensors and related accessories. Zener Eng. Co. provides optimal technical support in order to create the best possible customer satisfactory regarding the uninterrupted function of its equipment. This is achieved using over 60 trained personnel. Our colleagues in sales and marketing department and after sales services department are trained to give our valued customers consultation in finding the most suitable products for their need, design and execution of uninterrupted electrical systems while providing special solutions. In addition to manufacturing single and three-phase UPS, sealed lead acid batteries both with Zener brand, Zener engineering company is official and exclusive agent for Riello UPS (from Italy), Ablerex UPS (from Taiwan), Rocket and Newmax batteries (from South Korea), Interberg batteries (from Spain) and Starway batteries (from China).
All rights reserved
Design by: Hamrad Gostar Asia Technology Development